Binatone FM-4400 Installation Manual download pdf (Page 13)

Assembly

Sec. 3 Pg. 9

Step Procedure

Front Bumper

8.1 Attach Bumper [22] to Frame Weldment [12]. Fasteners: (4 ea.) Screws, self drilling

self tapping #12 x 7/8".

Step Procedure

Mooring Tube

Fig. H

7.1 Determine the location of the Mooring Tube Assembly:

FM 4400 - the rear Cross Channel [11] is preferred, the center Cross Channel is

optional.

FM 6600 - the center Cross Channel [11] is mandatory.

7.2 Attach Mooring Pipe Clamp [18] to Cross Channel [11]. Fasteners: (4 ea.) 1/2” x 1-

1/2” bolt, nut & lockwasher. Tighten these bolts at this time.

7.3 Insert short end of Mooring Pipe [19] into Mooring Pipe Clamp [18].

Adjustment: The distance from the center of the hoist to the inboard side of the

Mooring Pipe [19] should equal 1/2 of the boat’s beam plus 1 to 2 inches.

7.4 With the Mooring Pipe [19] properly positioned and vertical, tighten the bolts on the

Mooring Pipe Clamp [18]. Fasteners: (3 ea.) 1/2” x 2" bolt, nut & lockwasher.

Fig. H

HydroHoist Marine Group

Model: 4400/6600/ UL2FM

Publication: 10/14/08

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

No comments

Binatone FM-4400 Installation Manual Page 13